Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a hands-on DIY walkthrough of installing a block heater on a Massey Ferguson 1735M, replacing a freeze plug behind the engine access panel. It covers draining coolant, removing the screen and wiring harness plate, punching out the freeze plug, greasing the O-ring, and routing the cord, plus a tip that a $37 auto-parts universal heater works instead of the pricier dealer part. Best for owners planning this exact job.
Use a punch, tap it on one side with a hammer until it rotates in the hole, then grab the lip with pliers and pull it out.
No, a universal vehicle block heater from an auto parts store for about $37 works instead of the pricier dealer part.
Use a white grease, not anything petroleum-based, because petroleum products tend to eat at the rubber O-ring.
Yes, the engine coolant must be drained first using the drain cap with the rubber cover and pressure clamp on the right side.