Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →An owner-operator walking through the full 400-hour service on his Kioti CK2610, covering hydraulic fluid and dual filter swap (roughly 5 gallons, Traveler fluid from Tractor Supply), engine oil and filter change (Shell Rotella T6 5W-40), and fuel filter replacement. He skips front axle oil (warranty repair pending) and coolant (recently dealer-done). Shows drain plug locations, filter installation technique, leveling the tractor, and a post-service leak check. Most useful to CK2610 owners doing this service themselves for the first time.
About 5 gallons of Traveler hydraulic fluid, two hydraulic filters (regular and high-pressure), Shell Rotella T6 5W-40 engine oil (about 1.5 gallons), an engine oil filter, and a fuel filter.
The drain plug is approximately 30 millimeter, found in a Kioti toolkit, or you can use a large adjustable crescent wrench instead.
He found leaking seals on the front axle that are being fixed the following week under warranty, so the dealer will handle that service then.
After refilling and cycling the system once, he checks the rear hydraulic fluid dipstick, which pulls out easily and shows the fluid is at the right level.