Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →Focuses entirely on one practical task: measuring and cutting down an oversized PTO shaft so a new implement, here a ditch bank flail mower, doesn't damage your tractor's gearbox. Wade walks through the measurement process step by step, explains why you cut slightly shorter than the measured distance, and closes with the easy-to-miss tip about aligning the flat ends before connecting. Best for first-time tractor owners confused by PTO shaft fitment.
PTO shafts usually come too long, and connecting one without cutting it down first can cause major damage to the implement's gearbox or the tractor itself.
Wade measured 67 inches needed but the shaft was 70 inches, so he cut it to 66 inches, an inch shorter than measured, for extra clearance.
One end of the shaft is flat while the rest are curved; the flat ends must be aligned or the two shaft halves will not connect together.
Put the tractor's PTO into neutral so the shaft spins freely, which helps line up and connect the two ends of the shaft.