Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →Likely the only video showing a front fender kit installation on the New Holland Workmaster 120 (and compatible Power Star/100-120 hp models). Mike works through the poorly labeled hardware kit in real time, figures out grease fitting placement through trial, error, and a phone call, and ends up switching to a 45-degree fitting for access. Practical and unscripted, most useful to owners attempting this same retrofit.
Yes, Mike says it is a complete kit for Power Star and Workmaster series from 100 horsepower up, including the 100, 105, and up to 120.
The straight grease fitting location near the steering knuckle was too tight to reach with his grease gun, so he installed a 45 degree fitting for easier access.
Two longer bolts go in the back where there is more of a lip, and a shorter bolt goes in the front, with no washers used on this part.