Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a detailed DIY install video, not a review or dealer walkaround: an owner fits LED flood/spot lights and rear work lights to a Max28XL to fix headlight blockage caused by a raised snowblower. It covers the mounting plate fabrication, wiring routed through the roll bar and dash trim, harness splicing off the battery, and a nighttime before/after comparison with the snowblower up and down. Best for owners doing their own light upgrades.
When the snowblower is raised and you're traveling, it blocks the tractor's headlights, making it hard to see forward at night.
The wiring was run down through an existing crack in the roll bar, the access point used for folding the roll bar pin, avoiding any new holes.
The rear work lights are 4 inch Night Light brand lights rated at 18 watts each, mounted as backup or work lights.
Wires were spliced directly off the battery in the front of the tractor and routed back through the dash trim to the switch location.