Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a hands-on DIY install of a block heater on a TYM/Branson 3515, done with the loader still attached. The owner walks through removing the factory plug (a 1-3/8 socket, improvised with a wobbler and crescent wrench), draining a small amount of antifreeze, installing the heater with Teflon tape, adding a trickle charger, and refilling coolant. Useful for owners planning the same job themselves.
Posted by the One Man's Work channel, an owner documenting their own maintenance work on their tractor.
A 1 and 3/8 socket is needed, used on an adapter to a half inch drive with a long breaker bar.
Yes, the owner installs the block heater with the loader still attached, though reaching the plug requires a wobbler and crescent wrench.
About a third of a gallon, maybe a half, was lost and needed to be refilled after the install.