Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →An owner-shot walkthrough of the transmission fluid service on a Massey Ferguson 1526 at around 318 hours, covering drain plug locations, internal filter removal (including a tip that it pops out rather than threads), torque specs (23 ft-lbs for the filter, 48-65 ft-lbs for frame bolts), fluid refill caution, and part numbers. Filmed in segments due to camera issues, so the pacing is rough, but owners doing this job themselves will find the practical details useful.
No, it does not screw in or out. It is a pop-out filter with a seal, so you knock it loose and tap it back in with a hammer.
The recommended torque is 23 foot-pounds for the internal transmission filter.
The 8.8 grade frame bolts should be torqued to 48 to 65 foot-pounds, found in a separate reference book since it was not in the tractor manual.
Add fluid carefully since it is hard to see the exact level without using measured quart cans, then run the tractor briefly and recheck.