Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is the final installment of a multi-part DIY series on installing a 3rd function kit on an RK25, covering final wiring details: connecting the diverter valve harness, routing hydraulic lines with wire ties, wiring the relay to the battery, and running joystick wires through the tractor. The creator closes with an honest time/difficulty assessment (4-5 hours first time, 2 hours redo) and tips on fitting connections. Best for owners already mid-install, not newcomers wanting an overview.
An owner doing his own DIY install and documenting the real process, including mistakes and leftover parts, rather than a polished or sponsored tutorial.
Connect the tractor harness to the battery, red to positive and black to negative, then attach the relay to the battery hold-down post with an M6 nut so it does not flop around.
The creator spent four to five hours including making the video, and estimates it could be redone in about two hours once familiar with the process.
They run with cables toward the back of the tractor, pass through, come up, and plug in, with extra length looped and tucked out of sight.
The creator says it is not a super difficult job but not a beginner job either, so consider that before deciding to do it yourself.