Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A hands-on troubleshooting walkthrough focused specifically on blocked grease zerks, not just a general greasing tutorial. Tony works through two real scenarios: a loose or dirty fitting that won't seal, and a pin joint so dried out the passage is clogged solid. He shows the physical removal of the pin, clearing the blockage with a small screwdriver, and confirms success when grease finally flows through. Useful for anyone facing a zerk that won't accept grease.
First clean and tighten the fitting itself. If it still will not take grease, remove the pin behind it, since the passage inside may be dried out and clogged.
Take the pin out, then dig through the hole with a small screwdriver to clear the dried, clogged material before reinstalling the pin.
After clearing it and greasing again, grease goes right in without pushing back out, and grease is visible coming out on both sides.