Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a hands-on walkaround showing an owner greasing every Zerk fitting on a Kubota L3301 with a Harbor Freight pneumatic grease gun, including front axle, tie rods, drive shaft, and quick-release levers, plus a quick radiator screen cleaning and fluid check. It's practical and specific but casual, not a formal maintenance schedule walkthrough. Best for L3301 owners wanting a real-world grease-point tour rather than buyers evaluating the tractor.
Posted by Peterson Farms of Nashville DIY, an owner-operator homestead channel sharing their own hands-on tractor upkeep.
They are found on the front steering gear or drive shaft, tie rod ends on both sides, and the quick release levers. You need to look underneath the tractor to find them.
Keep pumping grease until you see old grease being pushed out and fresh red grease starts coming out of the fitting.
A pneumatic central air grease gun bought from Harbor Freight for about 20 dollars, loaded with Sta-Plex extreme pressure premium high red grease.
Pull the screen out, check for debris, blow it out with an air gun, and put it back in, also checking that coolant fluid is good.