Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a short, focused how-to on removing and reinstalling the loader on a John Deere 2520, filmed by an owner walking through the actual process step by step: releasing pin locks, using hydraulic controls to disconnect, uncoupling the four hydraulic lines, and reversing the process to reattach. It's a quick practical demo rather than a deep technical breakdown, best suited for owners wanting a fast visual reference for this specific task.
Appears to be an owner-operator sharing a hands-on demonstration from personal experience with the tractor.
Lower the loader, curl the bucket to release weight off the pin locks, lift to release the pins, use the motor control to move forward, shut off the tractor, cycle controls to release pressure, then uncouple the four hydraulic lines.
Hook the hoses back up, pull up and line up the mounts, reverse the removal steps, drive forward until they barely touch, pull back on the lever, slide forward and make sure it falls into place.
Four hydraulic lines, which uncouple like airlines by pulling back so they pop out.
