Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This video is a detailed, real-time walkthrough of removing a Kubota LX2980 front-mount snowblower from an LX2610, filmed by a long-term owner at end of winter. It covers relieving hydraulic pressure before disconnecting hoses, pulling the driveline, removing locking pins, and sliding the unit off onto pallets, plus practical tips on hose routing and the tricky pin on one side. Best suited to current front-mount blower owners wanting a step-by-step removal reference, not shoppers comparing tractors.
Appears to be an experienced owner-operator sharing hands-on maintenance from personal, repeated use of the equipment.
Put the key to accessory position, not on, then cycle the joystick or third function valve buttons into float to release pressure before removing hoses.
Start from the mid-PTO forward since that end has all the tolerance, grab the slip ring, pull the shaft out, then draw it back toward you.
After doing it once or twice, it is honestly a five to ten minute process, either putting it on or taking it off.
The nuts are welded in on the back of the frame, so although you normally torque nuts, these are welded and cannot be torqued.