Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →An owner doing this job for the first time on his John Deere 2038R, which gives the video a practical, problem-solving feel. He walks through draining coolant, locating the freeze plug (tricky with the loader on), removing it with a 1/2-inch drive extension, installing the element to 55 ft-lbs, and refilling with John Deere Coolguard 2. Best for 2038R owners tackling this themselves.
Remove a cover plate held by a couple of 10 mm bolts, lined up in a straight line off the mast, to get access to the plug.
A 1/2 inch drive ratchet or extension fits the square hole in the plug, and removing it requires a 1 3/8 inch socket since no wrench will fit.
The element should be tightened to 55 foot-pounds using the correct socket rather than just tightening until it feels good and tight.
John Deere Coolguard 2 pre-diluted, with the system holding a little over a gallon, about 1.2 gallons.