Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A step-by-step installation walkthrough of a hydraulic thumb on a John Deere 260B backhoe (also covering 270B and 370B fitment), sourced from greenpartsstore.com. The video follows the actual install in real time, removing pins, fitting the cylinder, mounting the valve bracket, and routing hydraulics, with beginner-friendly asides on tools and bolt types. It closes with a brief functional demo but defers real-world digging to a follow-up episode. Best for owners about to attempt the same install.
Yes, the same thumb fits the 260B, 270B, and 370B backhoes, though the valve bracket mounts in a different hole position for the 270B and 370B versus the 260B.
Lower the boom so there is no pressure on the pin, then use a large blunt drift punch and hammer to drive it out, followed by a narrower punch to align the hole.
No, it does not have an independent third function control. It is operated by the bucket curl and dump, with a separate valve to disable it when not needed.
The fittings are torqued to 27 foot-pounds using a 3/4 inch wrench.