Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a hands-on DIY engine-out job on a 574-hour Mahindra 2015 HST, done by an owner who's an auto mechanic but new to tractor teardowns, tracking down a rear main seal oil leak. It walks through detaching the front loader, pulling hydraulic lines, unbolting the bellhousing, and inspecting the clutch and flywheel, with running commentary on parts and Mahindra's support. Best for owners planning their own engine removal.
Detach the front loader, unplug and save hydraulic fluid from the lines, remove rear wheels, set the tractor on jack stands, unbolt the bellhousing, then lift the engine out with an engine support and a shop lift.
A rubber plug on the clutch bellhousing revealed about a quart and a half of oil. Inspection suggested it may be two flywheel bolts that were never properly sealed at the factory, not the seal itself.
The tractor had 574 hours and this was the first major problem the owner had experienced with it after owning it 12 to 14 years.
Yes, the owner, an auto mechanic new to tractor work, says it is not difficult and most people could do it themselves, though it took longer due to unfamiliarity with tractor procedures.