Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a follow-up field-mowing session showing the IronCraft 2510 flex-wing mower on a TYM tractor doing light clipping work at 6-7 mph, contrasted with an earlier slow, thick-hay cutting job. It covers pre-trip checks (oil sight glasses, bearing grease), towing tips, cruise control use, radiator temps under load (172-174°F), and a quick pass through a yard to show cut quality. Good for buyers curious about real-world mowing speed and cooling performance.
An owner-operator sharing hands-on homestead and mowing-job footage from his own equipment use, not a dealer pitch.
When just clipping, the operator mowed between six and seven miles per hour, compared to only one and a half to two miles per hour when cutting thick, four-foot-tall hay.
No, the radiator never went above 172 to 174 degrees while mowing at six to seven mph with the air conditioner running, even on a 90 degree day.
Grease the hinge bearings every mile or two of towing with four or five pumps of grease, being careful not to overdo it and blow out the seals.
The video shows one pass through an actual yard, noting the blades were not perfect but the cut looked like a zero turn had gone over it three times.