Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →An owner walking through a real repair job on a leaking KL130 tilt cylinder seal. He identifies the failure point, lists the minimal tools needed (pipe wrench, 11/16 socket), explains the assembly approach of leaving the cylinder in place and pulling the rod, and notes the parts cost just over $100 for both assemblies. Best for KL130 owners facing the same external seal leak.
Really not any special tools. You need a pipe wrench and an 11/16 socket, and that's about it.
No, you leave the cylinder in place. You pull the bolt and pin out, then pull the rod out to access and replace the seal assembly.
A little over 100 dollars for both parts, since the assembly comes as a complete unit rather than just the seal.
External leaking shows fluid running down the shaft from a bad spot bypassing the seal, while internal leak-by lets the bucket slowly drop without visible fluid loss.