Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A focused explainer on hydraulic fitting standards, NPT, O-ring boss, JIC, and BSP, specifically why mismatched threads cause leaks and how each standard seals. The host handles physical fittings on camera, walks through real-world failure modes for each type, and closes with a live BSP repair on an imported mower. Most useful to owners troubleshooting hydraulic leaks or shopping for adapters.
There is no universal standard for hydraulic connections, so mismatched threads get connected wrong, causing leaks.
O-ring boss seals with an O-ring that can degrade over time; JIC uses a 37 degree metal flare that seals tight but can deform if reused repeatedly.
Use a bonded washer fitting, no sealant or Loctite needed, just tighten it down and it seals without extra force.
It is an O-ring boss variant where the O-ring sits on the face instead of around the threads, and the O-ring can be replaced if it fails.