Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a hands-on repair video, not a walkaround: a Massey Ferguson 205-4 (about 1700 hours) comes in with front-wheel drive that won't engage. The video shows jacking it up, testing the linkage and driveshaft, pulling the front axle assembly apart, disconnecting tie rods, draining rear fluid, and reassembling with new seal and grease. Good for owners troubleshooting the same 4WD engagement problem, not for shoppers wanting a specs overview.
Posted by the Nash Summers channel, which appears to document its own tractor repair work rather than sell or review tractors.
Jack up the tractor, engage the lever, and turn the wheels by hand to see if the driveshaft spins and power transmits to the front wheels without even starting it.
Drain the rear fluid, remove four mounting bolts and three driveshaft bolts, disconnect the tie rods, then lift and slide the front end out.
After disassembly, cleaning, and reassembly with new seal sealant and grease, engaging the lever locked everything up, confirming the issue was fixed.
