Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A two-minute, no-frills walkthrough of clearing a clogged grease zerk on a tractor pin joint. Tony demonstrates the actual hands-on steps: cleaning the fitting, removing the dry pin, picking out the blockage with small screwdrivers, and confirming success when grease finally flows through. Depth is minimal given the runtime, but it's a focused, practical fix for anyone stuck on exactly this problem.
First make sure the fitting is clean, then remove the pin it feeds. If the pin is dry, the hole is likely clogged, so pick out the blockage with small screwdrivers until grease can pass through.
Reinstall the pin, attach the grease gun, and pump grease. In the video grease went in and did not push back out, then came out on both sides of the joint.
Not necessarily. In this case Tony checked the grease fitting and found nothing wrong with it, the real blockage was in the pin hole itself.