Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →An owner who ran two CT5555 tractors side-by-side, one with a 200-hour break-in oil change per the manual, one with an early 50-hour change, compares actual Blackstone Labs oil analysis results for both. The video walks through the specific wear-metal numbers (copper at 514 vs. 47, lead, tin, silicone) and draws a practical conclusion. Best for Bobcat CT5000-series owners wrestling with that exact break-in interval question.
Oil analysis showed much higher copper, lead, and tin at 200 hours than at 50 hours, so the owner concludes the 50-hour change is likely the better practice, though Blackstone was not overly concerned about either.
The 200-hour sample had copper at 514 versus a 7 average, 10 times average lead, and 37 times average tin. The 50-hour sample had copper at 47, about 7 times average, with lead and tin close to double average.
No, Blackstone Labs said the silicone is most likely harmless sealer and lube from assembly and should clear up after a few more oil changes.