Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A short teardown where Mike pulls a PTO shaft off his brush cutter, separates the male and female halves on camera, and explains grease points (u-joint zerks and the sliding shaft itself) plus the surprise that shaft profiles are not universal, there are roughly 50 shapes, and mismatching front and back halves is a real gotcha. Good quick primer for new implement owners who've never serviced a PTO shaft.
Tractor Mike is a longtime tractor-industry insider with decades of hands-on experience in the equipment business. He built his channel to help first-time and rural buyers make confident decisions, and his guidance comes from that deep, long-term background rather than a sales pitch.
There are grease zerks in the u-joints on the front and back, and the sliding shaft itself should also be greased so the halves slide together without water or rust causing problems.
No, there are probably at least 50 different shapes. The front and back halves must match, for example a shaft with three lobes where one lobe is flat has to line up correctly to reassemble.
Usually yes, but some, like a late model New Holland baler, have halves that look nothing alike. They only need to click together enough to carry the torque load.