Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a hands-on shop teardown of a leaking axle on a Kioti DK45SE, not a quick overview. It follows the full repair: pulling the tie rod and hub, draining oil, discovering metal shavings and a failed wheel bearing, replacing bearings, seals, snap rings, and a cracked cover, then reassembling and reinstalling the shaft. Best for owners troubleshooting an axle leak or wanting to see internal axle components up close.
In this case a failed wheel bearing let metal shavings through the axle, which smoked the seal and caused the leak.
Remove the tie rod end, drain oil, pull the cover, take out the shaft, remove the beveled gear and bearing, then install new seals back to back so the O-ring expands and seals under pressure.
The original cover had cracked or fractured from metal shavings passing through it, so a new cover was ordered and installed, sealed with silicone since it lacked an O-ring.