Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This isn't about a specific tractor purchase but a general operator's discussion on habits that shorten equipment life across tractors, skid steers, and excavators. It covers loader misuse as a bulldozer, travel speed with heavy loads, preventative maintenance like clearing zerks and cooling units, running RPMs hot under load, and excavator boom-turning wear on bearings. It's opinion-and-feedback style, not a spec walkaround, useful for owners wanting maintenance habit tips.
The loader was designed to move hay or similar material, not act as a dozer boom, and misuse causes broken bolts and bent loaders.
No, modern diesels with DPF filters only need about a minute to warm up, and manufacturers like John Deere say to run at half RPM right away.
An engineer said hammering the boom to turn is hard on the main bearing and should only be done when needed, such as on hard surfaces or to avoid tearing ground.
Cleaning grease zerks before greasing and blowing out cooling units, radiators, and air filters, especially cabin filters, in dusty conditions.