Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a hands-on install video, not a tractor review: Tony mounts an ITC Quick Attach brush/front guard on his TYM T574 after admitting he damaged the front end from loader/grapple work without protection. He walks through unbolting the stock setup, dealing with a warped bracket from shipping (ratchet-strap trick, drilling new holes), and torque tips, roughly a 20-minute job. Useful for T574 or similar TYM owners considering front-end protection, not for specs or buying decisions.
Tony is an owner-operator documenting his own homestead tractor work, and discloses a discount-code partnership with the guard's manufacturer, ITC Quick Attach.
Loosen the stock bolts, fit the guard's bottom ears into the holes from the inside, reattach nuts, then drill and bolt the upper mounting points using the supplied Allen hardware.
Tony used a ratchet strap to pull the bracket tight against the tractor before drilling new holes, applying just a couple pounds of pressure for a good fit.
Tony says the kit should take about 20 minutes, and even with using a ratchet strap to fix a warped bracket it still took roughly that long.
Only tighten until the nylon washer locks into place so it still allows the guard to hinge; do not overtighten or hammer it down.