Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →Cuts through John Deere's confusing Load-N-Go rollout by mapping exactly which decks and models are, and aren't, supported, with particular clarity on why the 54-inch 1-series is excluded. Then walks through a live install on a 72D deck, notes a minor fit-and-finish weld issue, and detours into mowing impressions and a grease gun demo. Best for owners trying to figure out compatibility before buying.
No. As of this taping there is no Load-N-Go available for existing 1025Rs or 1023Es with 54-inch decks, since the specs explicitly exclude that deck lift mechanism.
It works on the 2Rs and all 3-series decks back to the 3120, 3133, 2035, 2037, up through the 3033R to 3046R with 72-inch decks.
Yes, the turning radius of the 2038R and 2032R is much worse than the 1025R, though every other aspect is considered superior.
Yes, there is too much weld on the Load-N-Go itself, so the pin does not fit totally snug on either side.