Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a narrow how-to, not a tractor review: an owner installs Ken's bolt-on grab hooks and clevis mounts onto his Mahindra MAX28 XL. It walks through the actual DIY steps: drilling and deburring holes with specific bit sizes, cleaning metal, applying rust-reformer paint, then bolting the hooks and clevis on both sides. Useful mainly for owners planning this exact aftermarket hook installation, not for general MAX28 shopping research.
Posted by the joeynickdotnet channel, an owner documenting a DIY install on his own tractor.
A drill, half-inch and quarter-inch drill bits, a step drill bit, files, grade 8 bolts, half-inch and three-quarter inch wrenches, WD-40, and C clamps.
Yes, the owner cleans the metal with carb chill cleaner and applies rust reformer paint before bolting on the hooks.
The clevis is mounted on the inside, with the hook installed on top and bottom, and the same steps repeated on the opposite side.
