Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →An owner-operator's hands-on walkthrough of manually removing and cleaning the DPF on a Branson 3725 rather than running the prescribed high-RPM regeneration cycle, a practical workaround for tight job-site conditions. Covers locating the differential-pressure sensor, the removal sequence (10mm and 14mm fasteners, hose clamps), a Simple Green soak, and rinsing to clear water. Also documents a recurring broken barb fitting repaired with super glue. Most useful to Branson compact tractor owners facing their first DPF warning light.
Remove the sensor, disconnect the hose, take out three 14mm bolts and loosen two clamps to pull the filter, then soak it in a bucket of water with Simple Green for about 20 minutes and rinse until clear.
It sits with two lines running to each side of the filter, sensing the pressure difference that triggers the warning light when the filter plugs up.
Three 14 millimeter bolts hold the filter in place, and two hose clamps are removed using a 10 millimeter or 7/16 deep socket.
The owner broke the barbed fitting on the sensor while removing it and repaired it with super glue, but it popped off again during a later removal.