Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a hands-on DIY repair video, not a review: an owner documents replacing a broken transmission fan on his used GC2610, a known GC-series issue he couldn't find existing YouTube guidance for. He shows the tight crossbar clearances, drive shaft removal, the tricky trick of tucking fan blades into place, bolt sizes, and reassembly of the dash screen. Best for GC2610 owners facing the same repair, not shoppers.
Posted by an owner-operator (Rick, Twin Brook Acres channel) sharing a real trial-and-error repair on his own tractor.
Remove the drive shaft (one 12mm bolt), then bring the fan up over the crossbars, tuck the upper blades under the body, and fold the lower blades over the cross member until it pops into place.
Pull off the dash screen and inner screen (four to six screws, plus 10-12mm bolts), spray the splined end with WD-40 to loosen rust, then pry it off the spline.
No, the owner found the universal joints welded right to the drive shaft with no grease fittings, meaning the whole shaft would need replacing eventually.
The owner estimated about three and a half hours total, including breaks, due to trial and error with little prior knowledge of the repair.
