Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →An owner-filmed, in-progress walkthrough of adding an LED light bar and spotlights to a Mahindra 1626, covering dash console removal, switch cutout, wiring routing, heat-shrink splicing, and wire loom protection in practical detail. It also documents panel reassembly, including cowl removal and front nose tilt, with tips sourced from a Mahindra Facebook owners group. Best for 1626 owners tackling similar electrical upgrades.
Remove the cowl section that wraps between the hood and dashboard first, which reveals the other bolts; everything else is easier after that, taking about five minutes.
Use adhesive heat shrink over each cut wire end, crimp, then cover the splice with larger heat shrink, and run the harness through half-inch wire loom for protection.
Tilt the front nose grille forward using two large thumb screws, which creates a gap that makes removing and installing the side panels much easier.