Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →Part of a series, this episode focuses on rehabilitating a vintage Oliver moldboard plow, specifically cutting off rusted bolts with a grinder and swapping worn shins. Tim explains plow anatomy (share, moldboard, shin), why three-layer hardened steel wears the way it does, and how to manage badly corroded hardware without a cutting torch. Most useful to someone restoring an older plow or curious about vintage implement maintenance rather than a modern tractor buyer.
Use a cutoff wheel on a grinder to cut through the rusted bolt and nut, then use an impact wrench or hammer to knock it free once ground down enough.
The share, shin, and moldboard wear at different rates since the share contacts soil most, the shin wears next, and the moldboard, the most expensive part, is protected by the other two.
The steel has three layers, hard brittle outer layers resist wear while a softer middle layer gives strength, so once the first hard layer wears through the softer layer wears away almost immediately.
Farmers save worn parts like shins, share points, and disc blades since scrap steel is worth money, then eventually haul a truckload to local places that pay cash for it.