Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →An official LS Tractor walkthrough led by their senior service manager covering every pre-operation check on the MT242HC cab model: coolant, radiator, fuel-water separator, engine oil, air filter, radiator screen, axle fluid (with a useful paper-towel tip for reading the dipstick), battery, tires, lug-nut torque spec (140 ft-lbs), grease points, brake pedal free-play spec (2-2.4 inches), hydraulic fluid, and SMV placard. Straightforward reference material for new MT242HC owners.
Pull the yellow tab, rotate counterclockwise and remove it, then inspect the outer filter for dirt. Clean with compressed air from inside out, limiting pressure to about 72 PSI.
With pedals unlinked so they move independently, free play should measure 2 to 2.4 inches. Press down to resistance and measure with a tape, adjusting underneath the cab if needed.
Remove the dipstick, and since fluid is hard to see, roll a paper towel on it to reveal the level between the high and low marks, then reinsert and snug it up.
If lug nuts or bolts are loose, torque them to 140 foot-pounds, checking for rust trails or scoring that indicate looseness.