Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This video walks through the full process of shortening a compact-tractor PTO shaft, covering how to find the correct measurement by cycling the implement through its range, why you must cut an equal amount off both ends (not split the difference), what four pieces need cutting, and how to deburr the cut ends. A hands-on tutorial aimed at first-timers nervous about getting the length wrong.
Because the shaft overlaps, cutting only one end only removes half the length. To shorten it by one inch total, you must cut a full inch off both ends.
Raise and lower the implement through its full range to find the position with the shortest distance between the two shaft ends, and measure there.
You lose overlap between the shaft sections, which is dangerous because it can twist the shaft off or cause it to bend sideways.
Four things need cutting: each of the two steel shafts and each of the two plastic covers that slide over them.