Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A step-by-step practical guide on how to measure, cut, and finish a PTO shaft to fit your tractor, including use of an angle grinder and flap wheel, deburring both inner and outer shafts, greasing U-joints, and adjusting a slip clutch. Also covers the PTO Link connector as a hookup aid. Goes into genuine hands-on detail with common mistakes called out; most useful to first-time compact tractor owners fitting an implement for the first time.
Cutting only one side the full length and thinking it is done, since both sides must collapse evenly or it will hit the same collapse point.
Loosen the springs on either side and re-tighten the spring length based on your tractor's horsepower, following the manual that comes with the equipment.
It is a collar that attaches to the tractor so you only need to hook in, rotate, and lock the shaft with a pin, making hookup much easier.
Greasing keeps the U-joints protected, and you should wipe off dirt first so you do not push dirty grease or dirt inside the new joint.