Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A dealer walkaround of a fully-loaded NS4710 cab tractor, covering the Coyote grapple and loader setup, backhoe controls and quick-release removal process, cab features, three-point hitch details including the external lift lever, and an under-the-hood service walkthrough noting filter locations and access challenges. It goes reasonably deep for a sales-channel video. Best for buyers actively comparing NS4710 packages or wanting to understand what ownership and routine maintenance involves.
Pull two pins underneath the tractor, drop the outriggers and bucket, disconnect the hydraulics, and drive forward. Do this on hard, level ground to make reattaching easier.
A Coyote KG4066 grapple, 66 inches wide, was used since the standard bucket is 72 inches and grapples should run close to or a bit less than bucket size.
It is set further back and harder to reach. You move a piece out of the way, cut and re-zip tie it, then reach in to unscrew the cap and fill with a flexible funnel.
Yes, there is a lift and lower lever on the outside of the tractor linked to the cab controls, so you can raise or lower the arms while hooking up implements.