Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A real-work session video where a hobby homesteader uses a Kubota BX with a Land Pride RCR1248 rotary cutter to knock down six-foot weeds in a wet, muddy pasture. It covers pre-use maintenance (gearbox oil check, U-joint greasing) with a firsthand tip about a seal failure, then follows the actual mowing including getting the tractor stuck once. Best for BX owners curious about real-conditions brush hogging and basic rotary cutter upkeep.
There is a plug on the side marked by the dealer with paint pen. Remove the top vent and fill from the top until oil runs out of the side check plug.
Check the gearbox oil level on the rotary cutter and grease the U-joints and back wheel before starting to cut.
It can pop out the seal, an O-ring plate held by a snap ring, causing all the gearbox fluid to leak out, noticeable as a whining sound.
Raise it up off the ground as high as possible and go through to knock down the tall weeds without trying to cut them low.