Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A real-time install walkthrough of a grille guard on a New Holland Workmaster 40, filmed by the owner as he works through it. The video's value is in its unfiltered honesty: he runs into a blocking exhaust pipe, works around missing tools, and leaves some bolts un-torqued until he buys the right wrench. Useful for Workmaster 40 owners tackling the same install who want to know what snags to expect.
A 17 mm wrench (combination or crescent), a half inch torque wrench for the 80 foot-lb bolts, and ideally a 3/8 inch torque wrench for the 54 foot-lb bolts.
Yes, one U-bolt hole lines up right next to the exhaust, so a bracket bolt underneath has to be removed to give the pipe enough slack to move out of the way.
The upper bolts near the flange are supposed to be torqued to about 54 foot-lbs, and the lower bolts that hold the guard in the bracket are torqued to 80 foot-lbs.
No, the guard is designed to lift up and slide forward on a channel so the hood can still open, though it rests against the loader when down.