Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a manufacturer support video for WR Long's own hydraulic valve kit, not a tractor review. Josh walks through identifying valve components (body, solenoids, subplate, control module), safely relieving hydraulic pressure before removal, pulling the valve off the tractor, and disassembling it down to the spool, spring, O-rings, and push pin. Useful for owners troubleshooting or servicing a WR Long third-function valve kit already installed on their loader.
Posted by WR Long, the manufacturer of the valve kit, so it's a technical support video aimed at their own customers rather than an independent review.
Rotate the joystick back and forth and left and right until the loader quits moving, and operate the third function buttons to relieve pressure from the attachment.
The valve body, two solenoids, the subplate where four hoses connect, and the control module, which breaks down further into spool, washer, retainer, spring, push pin, core tube, and O-rings.
Yes, the smaller valve is symmetrical so it is possible to mount it 180 degrees in the wrong direction, so take a photo and note the side letters first.
Remove the plastic nuts and solenoids, take off the control module cover and its two screws, then remove the four socket head cap screws holding the valve to the subplate.