Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →Focuses on one specific DIY problem: making a Titan ballast box fit a Country Pro quick hitch from Tractor Supply. The creator walks through two pin-upgrade options, drilling out to 7/8 inch or fabricating a threaded-rod-and-bushing solution using 5/8-to-7/8 bushings, and explains why the bushing approach avoids cutting the box. Useful for anyone with this exact hitch-and-box combination.
You can drill the pin holes out to 7/8 inch for larger pins, or use a 5/8 inch threaded rod with 5/8-to-7/8 bushings that fit into the existing sleeve without cutting anything.
Drilling out to 7/8 inch may not leave enough material on the tab, so a bushing and threaded rod approach that uses the existing hole is a safer alternative.
Yes, because the hitch hooks are almost 1.5 inches wide, spreading the load across the pin and reducing bending even with the box full of crush stone.