Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a hands-on repair walkthrough, not a review: a technician diagnoses a 1025R noise complaint as loose carrier bearing nuts that chewed up the bearings and damaged the rear speed sensor, then replaces both. It covers removing the shaft, installing new bearing carriers with Loctite, setting bearing gap with a business-card trick, and reinstalling the sensor. Useful for owners troubleshooting similar noise, no-start, or dash warning issues on 1-2-3 series tractors.
Appears to be posted by a repair technician (NorthlandTechJoe) demonstrating actual shop work rather than a sales or review channel.
The nuts holding the carrier bearings came loose, causing the shaft to rattle, which wore out the bearings and ruined the bearings themselves.
A worn or shorted rear speed sensor can blow the ignition fuse, causing a no-start condition even though the dash lights come on.
Use a business card, or a specialty tool, placed between the parts to set the gap, then tighten the nuts down for a consistent gap.
Yes, the process is basically the same for 1, 2, and 3 series tractors, though the carrier part differs between models.