Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →Follows a real retrofit job across multiple shop sessions: removing pin bosses from a New Holland loader bucket, fitting Titan quick-attach arms, and troubleshooting a warped bucket back and an oversized plate. Shows the actual problem-solving, shimming, grinding, drilling, and pulling metal flush, not just a finished result. A brief demo of pallet forks at the end rounds it out. Best for DIYers considering the same conversion.
Cut the original pin bosses off, weld a quick attach plate on the back, notch it to fit the quick attach arms, then weld the Titan arms on and remount to the tractor.
Drill holes in the plate, use the holes to pull the bowed metal in with bolts after beating it with a hammer, then weld it flush once it sits tight.
There is talk that cheaper knockoff plates can pop open when back dragging with the bucket tipped down, so a more expensive plate was chosen instead.