Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This video centers on a specific practical question: is it safe to run a rotary cutter slightly larger than your tractor's PTO rating? Mike works through two real cases, a viewer's sub-compact paired with a 5-foot cutter, and his own 33-hp tractor eyeing a 7-foot twin-gearbox unit, covering front-end ballast concerns, tread-width matching, and when undersized horsepower is acceptable versus risky. Best for shoppers sizing a cutter to an underpowered tractor.
Tractor Mike is a longtime tractor-industry insider with decades of hands-on experience in the equipment business. He built his channel to help first-time and rural buyers make confident decisions, and his guidance comes from that deep, long-term background rather than a sales pitch.
Likely yes for cutting grass on flat ground with no saplings, but test it on a hill at the dealer first to see if the front end gets light when raising the cutter.
Put three or four concrete blocks in the front bucket as ballast, strapped in securely so they cannot fall out and get run over.
At least as wide as the rear tread width, or a little wider, otherwise you run over some grass twice before cutting it.
It avoids the long single spindle stretch, making it easier to store in a barn, and it sits offset to one side for cutting closer to fences and trees.