Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a step-by-step hookup demo, not a tractor review: a solo presenter attaches a used rotary tiller to a Yanmar YM2310, covering tiller width versus rear tire width, using the correct bent upper link for tillers, connecting the three-point arms, sliding and greasing the PTO shaft, locking its pin, and using a floor jack to align everything solo. Useful mainly for owners hooking up a tiller themselves.
Posted by Huff Tractors / ToughTractors.com, a seller of tractor parts like upper links, presented as a how-to rather than a sales pitch.
The tiller teeth should be slightly wider than the width of the tractor's rear tires, never narrower, so it does not leave tire tracks while tilling.
You need an upper link specifically made for rotary tillers, not a straight upper link, or the tiller will sit at the wrong angle and may hit the tires.
Slide the flexible shaft onto the tractor PTO, press the button to lift the pin, slide it through the groove, extend it to the tiller shaft, then lock the pin and grease both ends well.
Use a floor jack, placing a wooden piece under it, to lift and tilt the tiller enough to align and insert the upper link pin by yourself.