Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is part one of an owner's DIY install of a Summit Hydraulics diverter valve on a 1998 John Deere 5310 with an aftermarket Allied loader, done to eventually run a grapple. It covers hydraulic flow-rate considerations, fitting types, hose routing and lengths, joystick adapter sizing, and valve mounting, but stops before the grapple is attached and before any electrical wiring, which is saved for part two.
Posted by an owner-operator, Jim, documenting his own tractor project on the Dogwood Springs Outdoors channel.
They used a diverter valve from Summit Hydraulics, chosen because it seemed like the easiest and most affordable DIY solution for adding grapple function.
The hydraulic flow rate is about 11 gallons per minute, and the valve installed handles up to 13 gallons per minute.
Instead of using a tape measure, they used a piece of scrap garden hose with similar rigidity to route and mark the correct hose lengths needed.
No, the 12mm by 1.75 adapter they ordered did not fit, so Summit Hydraulics sent a tappable version the same day to resolve it.