Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →A short dealer demonstration showing a salesperson using a Massey Ferguson 1705 compact tractor paired with a Dirty Hands PD90 post-hole auger. It covers basic operation steps, positioning, leveling the bit, engaging the PTO, and clearing dirt, plus a tip on hydrostatic drive adjustment mid-dig and a storage trick. Runs shallow; no specs, pricing, or comparison. Best for complete beginners curious whether the task is approachable.
Back up to the marked hole, lower the three point, make sure the bit is straight up and down, engage the PTO, and slowly push the drill bit into the ground.
Yes, because it has a hydrostatic drive you can still move back or forward with the PTO engaged to adjust the bit if it gets off angle.
Once the bit is deep in the ground, bring it up and go back down a couple times to get most of the dirt out of the hole.
Dig a hole, leave the auger bit in the hole, detach the three point and PTO, and drive away, leaving it stored upright for next time.