Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →An owner-operator cleanup session on a 33-acre farm, this video follows Ed using the B2601 with a Land Pride box blade to grade a mess left from stump removal, then chipping shrub trimmings with a Woodland Mills WC68. The most useful content is candid: he documents two chipper jams, walks through the manual unjamming process step-by-step, and delivers a specific critique of the WC68 intake wheel design. Best for WC68 owners troubleshooting feed problems.
Put the feed in reverse, spin the flywheel backward by hand to back the limb out, then shift to neutral and forward again before resuming at a slower feed rate.
The intake wheel teeth are only about three eighths of an inch deep, so they slip off limbs around 3 inches thick instead of gripping and pulling them in.
Green, undried cedar, green pine, and boxwood clog the chipper because leafy, undried branches wrap around the drum and pack up on top.
The owner usually keeps the feed rate dial between number two and three, saying faster settings are only needed for smaller, three quarter inch limbs.