Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a raw, multi-hour vlog of one operator working through winter storm Izzy across three tractors: a New Holland 6030 with a worn-out snow blade, a John Deere running a blade and snow blower until its blower chain breaks, and a Massey Ferguson finishing the job with a single-auger blower. It covers real breakdowns, cutting-edge wear, chain failure troubleshooting, and drift-clearing technique, not a spec walkaround. Best for owners curious about long-duration snow-clearing reliability and failure points across different machines.
The HLA carbide cutting edge wore down to the bolt holes on the back and damaged the trip edge pivot, because it does not hold up well compared to a full-length carbide edge.
The chain that drives the augers broke, not at the master link, even though the auger drive has a shear pin that should have sheared instead.
The chain runs around one auger then straight to another without an idler in between, so there is not enough teeth contact on the sprockets.
The snow blower leaves the road staying clear longer, while pushing drifts with a loader, especially the wrong way, causes snow to blow back in quickly.