Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is an owner's DIY repair video, not a mower or tractor overview: it walks through replacing the broken steering wheel tilt/gas strut on a John Deere 5000 or 6000 series tractor, step by step, including removing trim covers, punching out the roll pin, and swapping in the new strut. Good for someone facing the exact same floppy steering wheel issue; skip it if you want mowing performance or implement coverage.
Posted by the F'nItUp channel, an owner-operator documenting a hands-on DIY repair on their own tractor.
Remove the trim cover using 8mm bolts, disconnect the ignition switch, punch out the pressed roll pin with an air chisel, swap in the new gas strut and spring, then tap the pin back in with a socket.
An air chisel with a small point was used after spraying penetrating oil, then a cheap drill bit was used as a punch to fully remove the pin.
The hydraulic catch on the steering wheel gas strut was not working, causing the wheel to flop back and forth on bumpy terrain.