Pick a make and model. Full spec sheet, owner videos, and similar tractors on one page.
Find a model →Pit up to four models against each other. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a narrow, task-specific how-to: loading net wrap into a Kubota round baler, not a review or walkaround. It walks through raising the front cover, storing rolls, routing wrap under the spreader roll and over the smooth roll, leaving about twelve inches of tail, setting the locking pin, and resetting the net wrap brake at the monitor. Useful mainly for Kubota baler owners needing a quick, concrete reference for this specific maintenance step.
Posted by the Johnson Tractor channel, presented as a hands-on operational demonstration rather than a sales pitch.
Raise the front cover, pull wrap from storage, route it under the spreader roll and over the smooth roll into the baler, leaving about twelve inches of tail, then set the locking pin.
The front storage area holds two rolls of net wrap.
Yes, raise the net wrap brake at the monitor before loading, then lower the net wrap brake again once the new wrap is installed and the locking pin is set.
