Pick a make and model. Full spec sheet, tractor videos, and similar tractors on one page.
Find a model →Compare up to four models side by side. Engine, hydraulics, hitch, weight, warranty.
Open comparison →Written guides on choosing tractors, hydraulics, PTO, hitches, and maintenance.
Read articles →This is a hands-on, step-by-step DIY fluid and filter change on a mid-80s Kubota B7200 HSTD, covering warming the fluid by driving the tractor, locating and pulling the drain plugs (transmission and both rear differentials), removing and cleaning the strainer, and swapping the filter with pliers. It shows real mess, real debris findings, and practical tips rather than specs or pricing. Useful for owners planning this exact job themselves.
It is right behind the mid-PTO on the left hand side, a fairly large plug that releases most of the fluid, roughly eight to ten liters.
Look right behind the rear wheel, not the first bolt but the next one over. It looks different from the other bolts. Same spot on both sides.
Yes, drive the tractor around for 15 to 20 minutes with the engine running to heat the fluid, since warm fluid drains better and carries out more sediment.
Two hands were not enough, so a large set of pliers was used to unscrew it. The threaded part should be screwed down gently before adding the new filter.